LED Lamp
Part List:
- some High Power LED’s
- thermal pads (thermally conductive, electrically insulating, double coated tape)
- alu L profile
- wires
- costant current driver matching your LED’s
Step1: align the number of LED’s your LED driver can handle equaly spaced on the profile. drill a hole at each end of the profile, so you can put the wires through.
Step2: cut the thermal pads to the size of the leds and tape them onto the leds. after that tape the leds onto the profile.
Step3: connect the LED’s in series
Step4: I used double coated tape to mount the driver on the LED’s side. make a knot in each wire before putting them though the holes, so you can use the wires to mount the lamp to the ceiling.
Tags: LED