IKEA Storm and powerRGB = GREAT

Here you can see my IKEA Storm Lamp Mod using the powerRGB circuit and the tinyRGB firmware.
day
Here are the steps:

  1. Assemble the lamp but leave the paper shield down
  2. Remove the contacts from the bulb’s holder:
    cimg1300
  3. Now open the holder
    cimg1302
  4. Build the powerRGB circuit on a PCB that fits the inner of the mounting:
    cimg1303cimg1309cimg1306cimg1304cimg1310cimg1311
  5. Solder some power supply cables to the PCB and pull them though the mounting down to the lamps base and put the PCB into the holder:
    cimg1313cimg1316
  6. So thats it. Now reassemble the lamp with shield and connect a propper power supply to the board.
  7. The most important step: Re-Design the Box:
    cimg1337
  8. Here some Images under Day-Light conditions:
    day
  9. And when darkening the room:
    night
  10. Enjoy your FÄRGRANN

Leave a Reply to tobias Cancel reply

Your email address will not be published. Required fields are marked *


+ three = 7

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>